Products

Wabtec Corp 3rd Rail Current Collector

3rd Rail Current Collector

3rd Rail Current Collector
3rd rail current collectors are used for the power supply of underground and urban railways. The raising to the respective conductor rail is carried out according to the customer specification via simple gravity systems to remotely controlled systems with impulse or continuous air.
 
The maximum vehicle speed with third rail shoegears is approx. 120 km/h. Application and lowering takes place manually or remotely controlled, i.e. by means of mechanical or pneumatic systems. Contact to the conductor rail is implemented via the following technologies:

Read more

Wabtec Corp Products Battery Charging Systems

Battery Charging Systems

The innovative Solution for High Power Chargers
Increasingly strict regulations to reduce pollution in the cities lead to a rapid change of the infrastructure to electric mobility. These are, for example, charging stations for cars or electric bus terminals.
 
Electric busses ensure for sustainable urban mobility. The retrofitting of bus routes solely driving with electric buses assumes a rapid development. Solutions are, for example, implemented together with local utility companies by rapid charging stations HPC (High Power Charger). Our charging pantograph is a key component of these charging stations.
 
Decades of experience in the development and production of power supplies, such as pantographs for local traffic and high-speed trains, make us a competent supplier for your electric bus terminals.
 
The technically demanding challenges for the specific conditions of electric bus terminals copes our charging pantograph...

Read more

Wabtec Cable Festoon Systems

Cable Festoon Systems

We manufacture lightweight and heavy-duty models of Cable Festoon Systems (plastics or steel), with rollers for C-rails, T-beams or tensioning ropes. The selection of the appropriate system depends on the respective situation at site, the cable type to be transported and its total weight. 
The cable trolleys are either made of plastics or galvanised steel and beared on rollers so they can be easily moved. They have a rubber or plastic plating so the transported cables are not damaged.
 
Festoon Cable Carrier
Cable Festoon Systems with C-rails can be used in many ways. For instance, they are installed on indoor cranes, in workshops or on outdoor surfaces, to implement a flexible transmission of current and compressed air or media.
 
CABLE FESTOON SYSTEMS

Read more

Wabtec Cable Reels

Cable Reels

Motor- and spring-driven cable reels are designed for the power supply to movable machines. The motor- and spring-driven cable reels are manufactured in accordance with the travel distances and the power of the movable machines. Regarding the version of the cable reel it is differentiated between cylindrical and spiral version. Which one of these versions is chosen depends on the customer’s resp. design-requirements. 
Special designs and the required accessories are innovatively produced by Stemmann-Technik corresponding to the customer’s requirements.

Read more

ChargingREEL

ChargingREEL

Our ChargingREEL is designed for ceiling, wall and underfloor assemblies and provides perfect adaptation to your e-fleet.
The professional design ensures reliable and durable operation.
Due to the individual cable routing and plug supply systems we are able to provide high flexibility in the implementation of the charging systems.
 
For more information please visit our website:
http://www.epower-charging.com/
 
or download our flyer:
ChargingREEL for electro vehicles

Wabtec Industrial Products Conductor Line Slip Ring Assembly

Conductor Line Slip Ring Assembly

SICL 10-system
The slip rings in the SICL10-system are based on our individually insulated conductor line SICL10. We manufacture slip ring systems with large diameters also in concentric designs, made to measure for the respective application. The minimum arc radius is 300 mm.
The SICL10-system enables flat installation heights and can be manufactured with housings, which can be separated. Combinations with our “WFo series” are possible.
 
Version
Slip ring material
plastic-insulated copper bus bar, if required silver-plated or nickel-plated
 
Brushes
carbon from bronze graphite or silver graphite
 
Speed
up to 18 m/min
 
Data transmission
with refined rings and silver graphite carbon
 
Housing
stainless steel or steel (galvanised or painted)
 
Protection class 
to IP 23
 
For more information...

Read more

Wabtec Industrial Products Conductor Lines

Conductor Lines

We manufacture conductor lines for any purpose, in closed or open design, i.e. with or without protective insulation against manual contact. Model, material and number of poles can vary depending on the area of application and purpose of use – exactly according to our customers’ technical requirements.
 
Safe power and data transmission
Our conductor line systems reduce the risks for man and the environment. Particularly when the manual carrying of power and data lines is hindering or even dangerous in the work area. We also offer all conductor lines as complete packages.
 
We implement the projects on location including mounting, control cabinet and all other required components depending on the requirements also in underground laid conductor lines and cable ducts. The design and quality of our conductor line systems ensure easy installation and nearly maintenance-free operation.
 
...

Read more

Wabtec Co Frost® Ground Contacts

Frost® Ground Contacts

The mechanical structure of our Frost® Ground Contacts meet effective national and international standards and directives. Material pairing is consistently optimized.
 
The design resp. working direction of the carbon brush is distinguished between axial and radial active contact system. Conventional round brush designs have been replaced by multiple brush designs in the area of standard applications. The reasons for this are, among others, the increased possible power transmission and in part, the simpler make-up of the contacts.  We have consistently continued to develop the successful path to multiple brush contacts and in the process, devised the successful frost® pressure system.
 
For more information please view our website: ...

Read more

Motor-Driven Cable Reels - Crane and Harbour Range / Mobile Construction Vehicles 1

Motor-Driven Cable Reels - Crane and Harbour Range / Mobile Construction Vehicles

Crane and Harbour Range
Find out where STEMMANN-TECHNIK-cable reels are used all around the world.
 
Here you can inform yourself about the following applications:

Read more

Wabtec Industrial Products Motor-driven Cable Reels

Motor-driven Cable Reels Open-Cast Mining Sector

Open-Cast Mining Sector
Our motor-driven cable reels provide for the reliable power and media supply of large open-cast mining equipment such as bucket wheel excavators, conveyor belts, cable storage, stackers or hydraulic excavators worldwide. We implement comprehensive customised solutions. From development and special design to commissioning and servicing.
 
To a certain extent, mobile open-cast mining equipment spans over large distances and is used far away from the location of the power input. Our cable storage devices and crawler-mounted cable reels enable the reliable supply of power in these fields of application and extend the radius of action of this large-scale equipment. Increased costs for fuel, the intensification of environmental requirements and economic saving measures are decisive for the decision of the manufacturers and...

Read more

Wabtec Industrail products Onshore Power Supply (SAMPS)

Onshore Power Supply (SAMPS)

Reduction of emissions in port
The emissions caused in the area of ports represent a growing problem because of the increasing capacities at the ports. To maintain the operability of a ship while in the harbour, the necessary power is normally generated by means of auxiliary diesel and generators while the main engine is switched off. In the future, the power supply for ships by means of onshore power supply units will replace the diesel-powered vessel generators to a large extent. The introduction of emission standards and environmental regulations in general are also accelerating this development. We offer systems and system components for the feeding of onshore power into the on-board power grid and in doing so, make our contribution to reduce the emissions of air pollutants, noise and carbon dioxide in the area of ports.  
 
For more information please view our website:
...

Read more

Wabtec locomotive freight car products Pantograph - Panto

Pantograph - Panto - DSA - Fb

Roof-Mounted Pantographs - Panto
Roof-Mounted pantographs for tram lines, metropolitan railways, metros, traction units (electrical multiple units - EMUs), trains and locomotives as well as potential special-purpose vehicles are developed for various overhead line systems and speeds, whereby a raising to and lowering from the overhead line is carried out by an electric or pneumatic drive depending on customer requirements.The continuous contact force to the overhead line at higher speeds is either realised by mechanical deflectors or by a specifically developed electric-pneumatic control system. If requested, an emergency drop is offered, which lowers the pantograph as quickly as possible in the event of collisions with the overhead line.
 
Local traffic
To meet the specifications and wishes of our customers, we manufacture powerful...

Read more

Wabtec product Mounted Pantographs - Overhaul, Repairs & Servicing

Pantograph Overhaul / Repairs / Servicing

Roof-Mounted Pantographs - Overhaul, Repairs & Servicing
Roof-Mounted pantographs for tram lines, metropolitan railways, metros, traction units (electrical multiple units - EMUs), trains and locomotives as well as potential special-purpose vehicles are developed for various overhead line systems and speeds, whereby a raising to and lowering from the overhead line is carried out by an electric or pneumatic drive depending on customer requirements.  The continuous contact force to the overhead line at higher speeds is either realised by mechanical deflectors or by a specifically developed electric-pneumatic control system. If requested, an emergency drop is offered, which lowers the pantograph as quickly as possible in the event of collisions with the overhead line.
Local traffic
...

Read more

Wabtec locomotive transit car products Rolling Stock Equipment

Rolling Stock Equipment (RSE)

Rolling Stock Equipment cistern products are used for filling fresh water tanks in passenger trains as well as for draining and flushing the wastewater tanks of the toilettes. The drain, flush and filling units are designed for one-hand operation.

Wabtec westinghouse air brake Industrial Products Slip Ring Assemblies

Slip Ring Assemblies

Slip ring assemblies for energy- and data transfer are being used for all products which do not allow any stationary current supply due to their rotary movement. 
 
Slip ring manufacturer - Made in Germany
 
Thus, the applications range from current transmission at slowly moving circular scrapers in purification plants to explosion-proof slip ring assemblies with media lead-through for oil production vessels and wind turbine slip rings.
 
Technologies
The slip ring assemblies and contact units for power and data transfers resp. signal technology are individually configured and manufactured for each requirement profile. We can resort to a wide range of standardised series and highly developed technologies, to implement the most ideal technical and economic solution for each customer. Even for complex requirements and extreme application conditions.
 
On this basis, these are manufactured according to the customers’...

Read more

Wabtec westinghouse air brake tech Industrial Products Spring-Driven Cable Reels

Spring-Driven Cable Reels

Spring-Driven cable reels serve for an orderly winding on and of cables, hoses or ropes - mainly for cranes, stacking devices or in wastewater engineering. Driven by spiral leaf springs, they represent a cost-effective alternative to motor-driven cable reels - in particular for mobile equipment without an independent power supply.
For a flash request please follow this link: http://stemmann.com/en/products/cable_reels/spring_driven_cable_reels
 
Cable-reels supplier
STEMMANN-TECHNIK manufactures cylindrical or spiral spring-driven cable reels in accordance with customer requirements - usually with slip ring assemblies for power and data transmission and if necessary, also as hose reels with rotary joints for different media.
...

Read more

wabtec corp westinghouse air brake tech railroad Stinger System

Stinger System

Stinger System
Stinger systems serve the power supply of parked vehicles in maintenance areas, e.g. for battery charging or other maintenance work, which must be conducted under vehicle voltage. Furthermore, with our Stinger systems, the vehicles can be moved within the depot or maintenance facilities by means of a control console.  The connection terminals of our 3rd Rail Current Collectors can be used as Stinger terminals by installing an arbor.  We manufacture and install complete systems according to customer requirements including conductor lines, plug and wire connections, control systems and arbors on railway vehicles.
 
Stinger system components:

For...

Read more

VarioPANTO

Variopanto® - Single-arm pantograph for cross-border rail traffic

Variopanto® - Single-arm pantograph for cross-border rail traffic
 
Electrically powered rail cars such as locomotives, EMUs and other vehicles are increasingly used in international border traffic. But as power supply conditions and overhead contact systems differ from one country to the next, each system requires the construction of an individual pantograph system.
 
Benefits:

  • The Variopanto® replaces two traditional pantographs
  • Adjustable collector head width for different overhead contact profiles
  • Reduction of weight and installation space
  • Space optimization in the cabin (e.g. additional seats)
  • Life cycle cost optimization
  • Reduction of noise

In answer to this challenge we have develope the Variopanto. Its collector head can extend to fit wide overhead contact profiles and...

Read more